Dissertation/ Thesis
Study on the processes of forming micro-gears by trough mould
| العنوان: | Study on the processes of forming micro-gears by trough mould |
|---|---|
| Alternate Title: | 溝道式模具成形精微齒輪製程之研究 |
| المؤلفون: | Hong,Bo-Wei, 洪柏瑋 |
| Thesis Advisors: | Huang,Guo-Ming, 黃國銘 |
| سنة النشر: | 2018 |
| المجموعة: | National Digital Library of Theses and Dissertations in Taiwan |
| الوصف: | 106 At present, traditional manufacturing technology cannot carry out a better quality manufacturing process for miniaturized gear by reason of the mould design cannot provide the material with an effective compressive stress. Following by the advance of technology and the innovation, most of the components toward the development of light and thin, miniaturization of components is an inevitable trend. It is difficult to produce micro products using traditional manufacturing technologies. This dissertation is used a trough-form blanking and extrusion cutting technology and can successfully produce high-quality parts in sheet (diameter 40mm thickness 10mm) and block (diameter 40mm thickness 30mm) material and can be better than the traditional technology. The technical characteristic is to design a ring trough-form on the mould that well provided a hydrostatic pressure to the material to resist the deformation of the tensile stress. Based on the above characteristics, the trough-form is a helpful to transfer technology into the manufacture of miniaturized gear parts, and it is a feasible and high precise forming technology. |
| Original Identifier: | 106NTOU5484014 |
| نوع الوثيقة: | 學位論文 ; thesis |
| وصف الملف: | 64 |
| الاتاحة: | http://ndltd.ncl.edu.tw/handle/44y9jr |
| رقم الانضمام: | edsndl.TW.106NTOU5484014 |
| قاعدة البيانات: | Networked Digital Library of Theses & Dissertations |
| الوصف غير متاح. |