Dissertation/ Thesis

CMOS Radio Frequency Device Model and High Frequency Power Performance

التفاصيل البيبلوغرافية
العنوان: CMOS Radio Frequency Device Model and High Frequency Power Performance
Alternate Title: 金氧互補式半導體射頻元件模型與高頻必v電晶體
المؤلفون: Jeng-Hung Lee, 李政宏
Thesis Advisors: JanneWha Wu, 吳建華
سنة النشر: 2007
المجموعة: National Digital Library of Theses and Dissertations in Taiwan
الوصف: 95
A research of CMOS BSIM4 DC and RF model parameters and power MOS transistor is investigated in this thesis. In the first part, a set of DC test devices which is fabricated by using TSMC 0.35 μm CMOS technology is designed for the BSIM4 CMOS DC model parameters extraction. It employs eight designs in the test set for measurement that all of the devices are implemented based on the design rule of TSMC 0.35 μm CMOS technology to obtain the reasonable BSIM4 DC model parameters. By the aid of extraction software ICCAP-2006A, the DC model parameters of 0.35 μm CMOS technology were extracted. A single-finger and multi-finger high-frequency devices are used to extract the RF model parameters in the second part. The DC model parameters in the first part will be also included to derive the RF model parameters. Some of calibration kits for de-embedded are used to verify the measured S-parameters and small-signal characteristic. Following the two steps, the BSIM4 RF model parameters will be obtained. The last part is a design of CMOS power cell. There are four devices with different sizes being built up of which are measured by a load-pull system for the output power, efficiency, power gain and the optimal impedance for load and source terminals.
Original Identifier: 095CCU05442042
نوع الوثيقة: 學位論文 ; thesis
وصف الملف: 102
الاتاحة: http://ndltd.ncl.edu.tw/handle/79489309304787717217
رقم الانضمام: edsndl.TW.095CCU05442042
قاعدة البيانات: Networked Digital Library of Theses & Dissertations