| الوصف: |
AlSi7Mg (F357) alloy specimens were fabricated in two different laser powder bed fusion (LPBF) systems: EOS M290 and SLM 280HL. Vertical (Z) and horizontal (XY) orientations were fabricated, and five different thermal post processes were applied to samples, individually. According to ASTM F3318-18, the considered thermal conditions were as-built, stress relieved (SR1), HIP, T6 and HIP+T6. Subsequently, the individual samples were aged at 140 °C and 177 °C for 100 h and for up to 1000 h. Tensile specimens were machined down from the aged samples and tested as per ASTM E8/E8M-21. While the yield stress (YS), elongation (%), and Vickers microindentation hardness (HV) were somewhat different for the as-built components, the general trends for the different heat treatments were essentially the same. As-built and SR1 treated microstructures were dominated by microdendritic cells, while the HIP, T6 and T6 + HIP component microstructures consisted of recrystallized grains containing eutectic Si particles of various sizes and shapes within the grain interiors and the grain boundaries; which gave rise to wide-ranging mechanical properties. As an example of these widely-ranging mechanical properties, it was observed that components fabricated in the Z or build direction in the EOS system exhibited a YS, elongation, and HV of 225 MPa, 13%, and HV120, while when HIPed and unaged exhibited values of 87 MPa, 25%, and HV51, respectively. These same HIPed components when aged at 177 °C for 1000 h exhibited values of 81 MPa, 41% and HV44. The mechanical properties of the unaged, HIPed and aged fabricated in Z direction in SLM system were 85 MPa, 31%, HV51, and 80 MPa, 42%, and HV47, respectively, providing support for LPBF system fabrication compatibility. These measured mechanical property values represent a small fraction of the more than 1600 mechanical property measurements (YS, UTS, elongation, and hardness (HV)) in this study. |
Full Text Finder