| مستخلص: |
Multipolar bonded magnets based on a thermoset matrix provide the opportunity to expand the applications of bonded magnets, especially within the drive technology industry, in terms of the high thermal and chemical resistance, along with a higher utilisation of the magnetic potential. To realize the application of polymer bonded magnets based on thermosets within the drive technology industry, general design parameters in terms of the material, the process parameters, and the tool concept are needed. These allow for a fundamental realization of multipolar bonded magnets with complex geometries in drive technologies, based on thermosets as the matrix material. This paper investigates the impact of the material (matrix material and filler grade), the process conditions (holding pressure (ph) and heating time (th)), and the tool concept (gating position and system, sleeve material, pole division, and sample thickness) on the magnetic properties in terms of the remanence (BR) and the deviation (Δs) of the pole division, as well as the orientation of the fillers in the middle of the pole and at the pole pitch. For each parameter, an optimised value is derived. In the majority of the cases, this value is equal in terms of the magnetic properties and the orientation. In terms of the sleeve material and the sample thickness, the ideal value differs between the two criteria. Therefore, an optimised value for each criterion, as well as an overall value, is defined. In terms of the material, PF, along with a high filler grade; in terms of the process conditions, a high holding pressure (ph) and a low heating time (th); and in terms of the tool concept, a two-pinpoint gating system, located in the middle of the pole, a Ferro-Titanit-Cromoni sleeve material, a high pole division, as well as small sample thickness, should be selected to improve the properties of polymer bonded magnets based on thermosets. [ABSTRACT FROM AUTHOR] |